Roll Bending

ACROSS THE WORLD, ALUCOBOND® A2 is the only non-combustible aluminum composite panel used in architecture.

Due to its non-combustible core, this fantastic product meets stringent fire regulations and hugely increases the possibilities when it comes to creative building design.

As with all ALUCOBOND® products, ALUCOBOND® A2 allows for simple processing, is impact-resistant, break-proof, and weatherproof – and above all non-combustible.

ALUCOBOND® A2 is the only non-combustible aluminium composite panel used in architecture world-wide. Due to its non combustible core ALUCOBOND® A2 meets the high requirements of the fire regulations and enhances the possibilities for the concept and design of buildings.

ALUCOBOND® A2, as indeed all the products of the ALUCOBOND® family, allows simple processing, is impact-resistant, break-proof and weatherproof and, above all, non-combustible.

processing images

Cutting

processing images

Punching

processing images

Contour Cutting

processing images

Bending

Roll Bending

processing images

Routing & Folding

p-riveting_01

Riveting

processing images

Screwing



ALUCOBOND® A2 can be bent using a roll bending machine (3 or 4 rollers). Make sure that the feeder does not exert too much pressure. Bending rollers which are also used for bending other metals must be thoroughly cleaned from swarf before processing ALUCOBOND® A2.

Make sure to use only polished rollers free of dents and other defects. To prevent damage caused to the panel surface, the protective peel-off foil must not be removed during bending. Additionally, the visible surface can be protected by using plastic pads of 1–2mm thickness. Before scaled-up production, testing on the sample panels is recommended.
ALUCOBOND® A2 can be bent using a roll bending machine (3 or 4 rollers). Make sure that the feeder does not exert too much pressure. Bending rollers which are also used for bending other metals must be thoroughly cleaned from swarf before processing ALUCOBOND® A2. Make sure to use only polished rollers free of dents and other defects. To prevent damage caused to the panel surface, the protective peel-off foil must not be removed during bending. Additionally, the visible surface can be protected by using plastic pads of 1 – 2 mm thickness. Before scaled-up production, first do the testing on the sample panels